Angelo

Fixed the problem in a round about way. Purchased a Rain Soft whole home water conditioner for the house (not a water softener as most think). Water had 11 grains of hardness and a lot of sediment. Test after install showed Zero with sediment removed. Had an independent water test done and it is actually 2 grains (still really really good) with no sediment. Bottom line...soap works really well and foams up ten times better. Car rinses clean with zero spots...in direct sun light. ...and no I didn't spend the money just to wash cars, I have family members with some skin issues and this helped clear it up.

Thanks...I will give it a try

Thank you. I will give it a try.

Followed your advice and sent an e-mail and pic to Adam's. We will see what they say about it.

Well I tried washing my Denali in the shade with the same results. It was 57 degrees outside. Complete shade and rinsed immediately upon finishing and again followed with the Metrovac as soon as I put down the hose. I am attaching some pics to show you guys. If I go back over the entire truck with waterless wash it looks perfect. first pic is the tailgate..second is the left side of bed. Pic of the shady lean to and the fourth pic is of the right side of bed. Last pic is after it is cleaned off with waterless wash. It is irritating to rewash the entire vehicle. Our water is not that hard and normally doesn't leave any water spots. I just spent over a grand on the ultimate kit and my results are poor. I must be doing something wrong. I have watched all of the videos and read all the directions. Any help would be much appreciated...if I call Adam's right now it would not be pleasant.....

Washed my black 2014 Tundra during an overcast day today. Outside air temp was about 58 degrees F. Did not need to rinse the truck before starting because it was not heavily soiled. Used the purple ultra foam shampoo in the foam cannon and then washed with the blue shampoo using the two bucket method. The soap did dry on the truck just like it did on the Caddy that Adam washed in the video. When I went to rinse off the truck after finishing the wash phase the streaks of soap stayed on the truck. I had to rewash and immediately rinse followed with the air dry from my Metrovac master blaster. I have four black vehicles and I purchased this system to alleviate pain of daytime washes. Bonus...there were no water spots, but it would not rinse off. Did I do something wrong that would cause the soap not to rinse off? Yes I have strong water pressure...62 psi. Washed the wife's new 2019 Mini Cooper JCW also and had no issues. Any help would be much appreciated.

Thanks DaleH. I might be getting some Ceramic wax then.

No doubt. Especially for the foam gun.😊

Before I make a mess that will take hours to fix. Need to know if I can put Buttery wax over Zaino's (C-Magic is same formula) or if I need to remove all of the old polish? I had a horrible time once when I put McGuire's detail spray on top of Zaino's. It hazed and would only smear around. Called Zainos...Sal actually answered and said it needed to use Z-6 to pull it off. He said carnauba only "floats" over the surface.. Good news, it came off. So is it okay or do I need to strip off the old Zaino's?

I will need to get some pics uploaded. Here is the list: 1951 Ford Custom Coupe 1967 Chevy Camaro 1994 Mazda Miata 1997 Miata Miata 2002 Mazda Miata SE (one of 1492 made) 2009 Pontiac G8 GT 2011 Chevy Corvette GS Convertible 2014 Totota Tundra TSS Offroad 2015 Mini Cooper Base 2017 Mazda Miata RF Launch Edition (One of 1000) 2018 GMC Denali HD 2019 Mini Cooper JCW Edition Promise to get some pics Angelo

Just wanted to say hello. Been detailing cars for about 35 years. Figured I would give Adam's a try. Thank you in advance.