Fierce5

It's possible that the clear coat was painted on top of the scratches. Just a possibility but I doubt that's the case with a car like this

Also, the made in the USA is a huge difference. Personally, I'm big on not just buying US made products but US made products manufactured by US companies. In other words, I don't consider a Toyota Camry to be American just because it's made in Tennessee! In short, American products cost more and that's one of the reason there is a slight difference in price between Adams and elsewhere.

Definitely rubber must be taped and if using the drill the paint too

You will need to use the Paint Correcting Polish and a 4 inch orange pad. If it doesn't become significantly better you can use the 4 inch pad on a drill but make sure any paint surfaces are taped off. The picture below shows before (left) and after (right)

Have you tried spraying all purpose cleaner on a clean microfiber towel and see if they can be wiped out? If that's doesn't work then you're better off polishing them with a 4 inch pad and fine machine polish

Congrats Dan! What's the new ride?

Looks good. I should be there for Corvettes in August. Hopefully you guys will be there too

This is one of the most underrated cars of all time! Beautiful and looms sharp. Enjoy it!

I rinse the engine bay first with the water on fan setting to avoid any aggressive contact between the water stream and sensors etc. I then spray a heavy duty degreaser all over the engine bay and let it sit for few minutes then agitate. Next, I use my Mytee steamer to steam the engine bay and make sure to get the dirt out of all the tight areas Finally I apply SVRT and In and Out spray

Was the set angled as well?

I don't see that Adams is selling the set anymore, only one. Is the set coming back?

Thank you! And I agree with the gas door and cap

Looks really nice!

She's so cute, God bless her!