Big O

One more time with apc and scrub brush then finally got the power washer out and took it down to black.

Probably try the pressure washer tonight and then just go with dressing after that

First round i wet the rubber and soaked with full strength apc. then scrubbed with brush and soap, rinse. Second round was a longer setup time for apc and followed with stronger soap amd water with synthetic bristle brush and lots of scrubbing on every square inch of rubber.

they were dressed with SVRT and dirty roads turned em brown. It is dirt clinging to the SVRT i believe, if i rub my hand over the brown parts my hand gets dirty.

This is after two rounds of soap and apc with brushes. Any ideas to clean this up?

This weekends daily special might be a good start also

There is a military discount, whatever you do make sure to get that code to save some hard earned money!

the canon rules! I got to play with mine yesterday ... ear to ear smile

Niiiiice

That is very cool ... I will let the younger guys or guys hard up jump on this ... you guys rock

VB is virtual bulletin board or something like that ... its the software our forum is using.

Powered by vBulletin® Version 3.8.6

The pdr guy I've watched push them out from the inside, your paint shouldn't be touched by his tools. For instance, your door, he will take off the interior panel and push it out from there. But I've only seen it done by one guy.

Leave em alone, work around them, and knock it out. Throw a detail in on the truck also so he is overly happy and thank him for the use of the garage

If you think your gas and expenses are bad ... these poor bastards going to work in ND are getting raped daily by local people trying to cash in without working the patch. According to people I used to work with who have now gone to ND to chase the almight $