I got it scrubbed again and powerwashed clean. I did not dilute the svrt, just went nice and zlow with the foam block. Looked at the wifes yukon last night and they got dusted again, gotta love living in wyoming.
First round i wet the rubber and soaked with full strength apc. then scrubbed with brush and soap, rinse. Second round was a longer setup time for apc and followed with stronger soap amd water with synthetic bristle brush and lots of scrubbing on every square inch of rubber.
they were dressed with SVRT and dirty roads turned em brown. It is dirt clinging to the SVRT i believe, if i rub my hand over the brown parts my hand gets dirty.
The pdr guy I've watched push them out from the inside, your paint shouldn't be touched by his tools. For instance, your door, he will take off the interior panel and push it out from there. But I've only seen it done by one guy.
If you think your gas and expenses are bad ... these poor bastards going to work in ND are getting raped daily by local people trying to cash in without working the patch. According to people I used to work with who have now gone to ND to chase the almight $