Geoimpression tool hit the concrete

[Junior]

I had my claying tool hit the driveway today. YIKES! I rinsed it off pretty thoroughly. Thought I would post about it to make sure I am okay to do that and keep using it. Anyone else had this happen?

 

Just to be clear, the clay was not on the tool at the time.

Edited May 25, 2016 by Junior

[Gen9Rolla]

Since it doesnt have a sticky or microfiber cover, it'll be just fine after rinsing. Just make sure you rinse it well and check the pattern for little bits that may be stuck in there. I would even run a brush over it a few times

[Junior]

Thanks Justin that's a good idea about a brush. I am going to try that.

[Ricky Bobby]

I'd brush it out with some APC and trim and lug nut brush then blow dry it with Sidekick

[Junior]

Thanks Mr Bobby. That's a good idea! I don't have a sidekick. But one day hoping to pick up a MB.

[Ricky Bobby]

You could prob use the wifeys hair dryer on cool setting or maybe a leaf blower in the meantime - the MB is a great tool if you have the coin - although I am partial to my Sidekick and the tons of uses I keep finding for it considering the $70 paid.  Super awesome bang for the buck.