Ceramic Boost

[NVEOUS]

Hey guys and gals, I got some of the original ceramic boost in my mystery organizer recently and I finally went to try it out. I was excited and followed the directions, but the streaking was awful! What can I do to combat this? I’m new to Adams and I used it on two panels and wasn’t happy with it. I ended up using my spray wax to even it out. Hopefully this isn’t a duplicate post. Any help would be appreciated!

 

Thanks in advance!

[tlbullet]

Definitely try using much less product.  What i do is i hit the entire car with minimal product.  Then grab a fresh MF and lightly wipe down the streaks if they are present.  

[Chris@Adams]

I agree less is more also work in shade and have several clean MF towels on hand.

[Rich]

Bingo!  Less is more. I use it on my black Equinox, and if I use too much, it will streak. So use less, smaller areas at a time when applying.  You'll be happy.

[Nickfire20]

You can also try spraying it in a double soft towel, then wipe it on the vehicle, usually a little easier as well.

If needed, waterless wash or ceramic waterless will level it well.

[Yo-Yo Ma's Cousin]

I agree with all. Less is better with CB. Also like @Chris@Adams said, have several clean and dry microfibers ready. If your towels get too saturated, switch to a new one.