Adam's ceramic coating

[big_a_srt]

So I coated my jeep and just had a question. This thing always get dusty what should I use to get dust off. As I don't want to wash every time it gets dust and don't want to hurt the coating.Would a spray detailer over ceramic work? I use ceramic boost every 3rd wash or so ant advice. Thanks in advance for the help.

[Nickfire20]

Jeep looks great!
 

Theres a few ways I go about doing this.  
And I change it up from time to time...

 

-an air dryer, ie Adam’s Air Cannon

-waterless wash

-CS3

-pressure washer only, no soap and bucket, then use air dryer

 

 

Just know the proper technique to using waterless and CS3 on a dirty vehicle.  
You want to saturate the surfaces, wipe in straight lines while pulling up and away.  Always flipping the towel over to a clean area.

[big_a_srt]

54 minutes ago, Nickfire20 said:

Jeep looks great!
 

Theres a few ways I go about doing this.  
And I change it up from time to time...

 

-an air dryer, ie Adam’s Air Cannon

-waterless wash

-CS3

-pressure washer only, no soap and bucket, then use air dryer

 

 

Just know the proper technique to using waterless and CS3 on a dirty vehicle.  
You want to saturate the surfaces, wipe in straight lines while pulling up and away.  Always flipping the towel over to a clean area.

Thanks ill look into CS3 and waterless. Thanks again for the tips 

[Rich]

Use the CS3. It's basically a ceramic waterless wash.  Maintain with Ceramic Boost. 

[big_a_srt]

Yeah I'm going to drive down and pick some up thanks for the tip

Edited July 10, 2020 by big_a_srt

[Chris@Adams]

My go to here lately is CS3, it's starting to be my favorite product.

 

https://adamspolishes.com/collections/new-just-in/products/adams-cs3-basic-kit

[RayS]

I have a gallon Ceramic Waterless Wash and plenty of CS3, so I tend to switch between them.  I'm not sure if I'll purchase another gallon of Ceramic Waterless or just use CS3 once it runs out.  I have noticed that the Ceramic Waterless works a little bit better on bugs if you squirt a little on the bug, when wait a minute or two to wipe it off.  If the wife has hit multiple bugs, then I'll do the front with Ceramic Waterless, even if CS3 should be in rotation and then go over the entire vehicle with CS3.

[big_a_srt]

Thanks for the tip 👍.